Abrasive Hardware

Abrasive hardware describes a group of tooling components that hold abrasive finishing products such as cartridge rolls, cut-off wheels, polishing buffs, wire brushes, and finishing wheels in place.  Designs will vary depending on the abrasive product being used. Always remember to use recommended safety equipment when working with hand and power tools.

For more information check out the following: Abrasive Hardware Infographic.

Abrasive sanding drums are used to mount an abrasive sanding sleeve. The rubber drum expands to hold the sanding sleeve in place. Sleeves are secured on the drum by controlled expansion of the solid rubber drum spindle. The rubber provides a cushioned backing to assure a smooth, even finish during use. Always remember to use recommended safety equipment when working with hand and power tools.

For more information check out the following: Abrasive Sanding Drums Infographic.

Used in conjunction with power tools, Climax abrasive mandrels are driven primarily by direct connection to an electric motor. Consisting of a shank, nut, and washer, mandrels are used to hold abrasive sanding/finishing or polishing products in place. Quick change styles do not incorporate washers or nuts therefore limiting the amount of time required to replace the finishing product. Climax abrasive mandrels have a rust proof finish.

Climax motor arbors mount directly onto the shaft of a motor using the set screw included in the product design. Motor arbors hold abrasive finishing products in place similar to a mandrel. Some motor arbors have an internal thread which allows for a threaded shaft. This internal threaded design permits the use of thicker finishing wheels. Climax motor arbors have a rust proof finish.

A keyless chuck is simply a holder that allows you to mount and hold different tools such as drill bits, abrasive tools or sanding drums. Climax keyless chucks are manufactured to mount on a 1/2-20 threaded shaft. Tightening or loosening the chuck will open or close the jaws allowing for installation or removal of various tools.

Climax abrasive sanding sleeves are spiral coated-abrasive bands with resin-bond aluminum oxide on a hard cloth back. These abrasive spiral sleeves can be used with Climax rubber expansion sanding drums.

Climax rubber expansion sanding drums are offered in three different styles; screw lock, nut lock and quick lock.

Standard Screw Lock – with Shank: The rubber expansion on the standard screw lock sanding drum is controlled by tightening or loosening the slotted screw at the end of the mandrel.

Standard Nut Lock – with Shank: The rubber expansion on the standard nut lock sanding drum is controlled by tightening or loosening the hex nut at the end of the mandrel.

Quick Lock – with Shank: The rubber expansion on the quick lock sanding drum is controlled by simply tightening or loosening the rubber spindle by hand. The design of this sanding drum does not require the use of additional tools for installation or removal.

Power tool accessories and hand tools are dangerous when used improperly. Comply with all safety regulations and always protect face, eyes, and body when using hand and power tool.

The sole purpose of an abrasive sanding drum is to mount an abrasive sanding sleeve. The rubber drum expands to hold the sanding sleeve in place. Sleeves are secured on the drum by controlled expansion of the solid rubber drum spindle. The rubber provides a cushioned backing to assure a smooth, even finish especially when finishing items with curves or contours.