Featured Products



Re-Machinable Couplings
R2CC-Series  
These unique two-piece rigid clamping couplings come with an undersized ID which allows you room to re-bore the ID without damaging the clamp screws. The pilot bore can be opened safely to the nominal ID reflected in the part number.

R2CC-Series
Pilot Bore Sizes: 1/4" through 1"
Available in:
Stainless Steel,
Steel-Black Oxide Finish
Two-Hole Set Screw Collars
C-2H-Series  
Two-Hole Set Screw Collars
Load capacity is nearly doubled by adding a second screw
Holes are at 90 degrees

C-2H-Series
Bore Sizes: 1/4" through 2"
Available in:
Steel-Black Oxide Finish
  Nylon Shaft Collars
NC & N2C-Series  

Will not rust or corrode
Ideal for wash down environments and USDA approved
Collars include stainless steel screws

Nylon Set Screw Collar
NC-Series
Bore Sizes: 1/4" through 1"

Nylon Two-Piece Clamping Collar
N2C-Series
Bore Sizes: 1/4" through 1"
  Corrosion Resistant Collars
CRC-Series  

For use in hostile environments such as Food, Washdown, Pharmaceuticals, Mining, Marine, etc.

Corrosion Resistant Set Screw Collars
CRC-Series
Bore Sizes: 1/4" through 1-1/4"

Corrosion Resistant Two-Piece Clamping Collar
CR2C-Series
Bore Sizes: 1/2" through 1-1/4"
  End Stop Collars
ESC-Series  
Fits over rail assembly for precision shafting.

End Stop Collar
ESC-Series
Bore Sizes: 1/2" through 1-1/2"
  Drill Stop Kit

Drill stop collars make it easy to drill holes to a uniform depth.
Kits consist of 7 set screw collars that firmly grip the outer diameter of the drill bit.
Sizes include: 1/8", 3/16", 1/4", 5/16", 3/8", 7/16", and 1/2"
Hex keys enclosed for easy installation.
Drill Kit #100
DK-Refill Kit #101 (collars only)